Oil cooler for ford 6cly

Philip Hodson · 04 October 2005, 23:52

Any one got a oil cooler for a Ford 6 cyl (Bowman I think )
all most the same as my turbo 4

Scary Des · 05 October 2005, 08:29

Do you need the whole thing or just the core

Des

Philip Hodson · 05 October 2005, 18:51

Just the body Des.
Mermaid want £150 for the whole unit

Phil.

jackcastoff · 05 October 2005, 20:29

Is it the one that bolts directly on to the block, where the oil filte woul dnormally go?

Then the oil filter would screw on to the cooler?

Or is it a stand alone unit ?

If it is the one ive mentioned, I can put you on to someone that has one.

Paul F · 05 October 2005, 22:44

I have a brand new spare oil cooler that i got for our hard boat, stand alone type, small bowman, can get numbers off of it tomorrow, if its any good to you, you can have it for 40 quid (new is about 80)

Philip Hodson · 06 October 2005, 18:25

Paul is the water straight through or are the end caps angled
we need the straight

Phil

Paul F · 07 October 2005, 20:15

Here goes, it has the following on alloy casting EC80 and EC21, 1 1/4 hose end oneach end(straight through). 2 threaded ports on top for oil, alloy body is about 4 inches long then the end caps which are held on by 3 allen bolts.Number on plate is 20281.
Paul

Philip Hodson · 08 October 2005, 10:48

Paul
Sounds just the part how can I pick it up from you
Phil (private message?)

Paul F · 08 October 2005, 16:05

Hi,
PM me with your address and will send it during week for you.

Philip Hodson · 13 October 2005, 08:59

Paul did you get my PM if not i will try again

Phil.

Paul F · 13 October 2005, 22:29

Phil,
I PM you last night
Cheers
Paul