Transom pad needed - anybody have a source ?

[Boats&Outboards]

Looking for a large transom pad like the one shown in this picture. It needs to be around 10mm thick.

Anybody have or know of a supplier or somewhere I can get the material to make one ? Ideally close to Plymouth

I've searched all the usual places and can only find the small pads for a dinghy. Have tried some usual DIY outlets but nobody seems to stock the white Perspex (or plastic acrylic) type material it is.

Any ideas ?

Peter @ Boatsandoutboards4sale ~ askboatsandoutboards4sale@sky.com ~ 07930 421007

[benc]

Might be worth asking over on boat mad for this too

[SPR]

http://www.amariplastics.com/

might be able to help...

S.

[Searider]

Chopping board?

[Boats&Outboards]

Thanks. All sorted thanks to "NuSigns" of Plymouth. Managed to get an off cut of 12mm acrylic Perspex in white for just £15. Fitted the motor and it's almost ready to go.

Just got to wire up the on trolls and it's on the water.

Peter @ Boatsandoutboards4sale ~ askboatsandoutboards4sale@sky.com ~ 07930 421007