Which thread?

[Nomountainshere]

Trying to mount at tiller extension on the Tohatsu – run into a bit of bother; The M10 studs, or what I believed to be m10, in the motor are not M10 – the are more or less the same diameter (+/- a few thousands of a mil), but the thread is rather fine. All other bolts on the Tohatsu are metric (so far), so I’m hoping that this is something not too exotic. t this now could be ?

I’ve tried to mark it on the picture - part number 9152e3-0845. Any input ?
Thanks

[uncle al]

1/2 inch A/F thats a UNF thread?

[beamishken]

Probably metric fine measure the pitch

[Nomountainshere]

So, in case you are interested: it's M10x1,25 - and extremely difficult to find in stainless around here. Well, I bought the boat, I must pay.

[Pikey Dave]

M10 fine then. If you can't find one, I probably can. If you get stuck, drop me a line.

[beamishken]

I'm sure I got some off eBay a little while ago or take up Dave's offer

[beamishken]

Look at this on eBay http://www.ebay.co.uk/itm/191768641287