yamaha 115hp aeto and ceto wiring diagrams

[tim86]

hi guys, so bought a blown up yamaha 115hp 2 stroke ceto motor for my boat, after looking into the engine damage ive decided i want to bolt my running yamaha 115hp 2 stroke aeto motor into the ceto chasis??

i want to firstly know is this possible will the mounting holes line up along with output shaft and shifter?

second i want to use the ceto electrics as the aeto electrics are quite junk and old. is this possible to??



tim

[Ribtecer]

https://www.yamahaoutboardparts.com/...outboard-forum

Somebody here will know.

Good luck.

[phantom 19]

It will physically fit the gearbox, tray and leg fine, however you have to keep A electrics with A block and C type electrics with C block as all the cast mounting points are completely different between the AETO and CETO.

[tim86]

thanks phantom, ive kept the mounting brackets from the c motor. ile strip the a motor down and see how much is differant, worst case i will ziptie stuff on haha

[phantom 19]

You’ll need a lot of zip ties and metal ones too. It’s all completely different, not just slightly. Different pickup under the flywheel, coils etc you might as well be trying to attach a set of mercury electrics to it

[tim86]

so i had a quick look yesterday, seams the valley plate has a fitting on the bottom of it for a water intake,lucky i kept that plate off the new motor coz it bolts straight back on.