Honwave T40 owners

[RiPsTa]

I bought a Honwave T40 at the weekend with the front wood section of the floor is missing, are there any T40 owners who could make me a template of just the front wooden section so i can make one to fit. I could probably make one somewhere near without but fearing if its slighlty too big might rub through the tubes or put too much stress on the seams

[dave3235]

Originally Posted by RiPsTa

I bought a Honwave T40 at the weekend with the front wood section of the floor is missing, are there any T40 owners who could make me a template of just the front wooden section so i can make one to fit. I could probably make one somewhere near without but fearing if its slighlty too big might rub through the tubes or put too much stress on the seams

Hi

If i was you as long as the boat is otherwise in good condition,Buy NEW the price will be around £100.Make sure you Inflate to Correct Presure once its had time to adjust to Water Temp,or risk cracked floor.

[RiPsTa]

I've been looking online for one but can't find anything, any suggestions?

[dave3235]

Originally Posted by RiPsTa

I've been looking online for one but can't find anything, any suggestions?

Hi

Just do google search for places to buy HONWAVE INFLATABLE BOATS should come up with some answers, probably near you.If not I will post you a number near me.

[Landlockedpirate]

Making the front piece is easy, it doesnt even have to be exact measurements. The problem will be finding the joining piece to attach it to the 1st piece of aluminium deck.(Unless you are lucky and its still attached).

Just measure the size and make it out of 9mm ply, make sure you round the edges off to minimise rubbing. Honestly its easy, took me less than an hour to do, just dont forget to cut a hole for the keel valve.

[RiPsTa]

Yeah i think i will make one, phoned a couple of dealers today and rang a couple more aswell and i've had no reply off any of them

I'll pop to wickes for some marine ply tomorrow and i have some lovely moisture cure paint left over from the last time we painted the factory floor which will look almost original as its a siimilar grey

[RiPsTa]

Well changed my mind again!, 2 hours into looking at H section aluminium extrusion's this morning i got an email back from one of the dealers with a price of £72 inc vat and delivery so i've just gone with that as i know its going to be spot on and i needed to order a couple of smaller parts aswell so they will share the postage cost.

[dave3235]

[QUOTE=RiPsTa;632003]Well changed my mind again!, 2 hours into looking at H section aluminium extrusion's this morning i got an email back from one of the dealers with a price of £72 inc vat and delivery so i've just gone with that as i know its going to be spot on and i needed to order a couple of smaller parts aswell so they will share the postage cost.[/QUOTE

Hi

Thinking ahead if you have no presure guage buy one.After putting in the water you will see how the presure drops.Its an essential bit of kit for sibbers.