Quicksilver inflatable 4.3

[Dydigital]

Does anyone have a quicksilver 4.3 (AA4300048 ) and would not mind doing me a huge favour?

I am missing the bow D shaped floor panel, if someone out there could measure there's I would be most grateful.

I will then hand one made up.

Thanks

Mike

[The Gurnard]

Hi Dydigital... if you can wait until the start of next week..I should be able to post rough measurements from mine.


The floor is in my SIB at the mo..and I wont be taking it out again for a good while as it is a pita to remove and I put it all back together a month or so ago after re painting the flooring for the winter. I keep mine assembled on a trailer. However I can measure it insitu and post the info when I next get to the boat..which will be early next week.

[Dydigital]

Thank you very much, I am in no rush, don't pick it up till next week. And grateful for any help offered.

[Dydigital]

Just had a phone call from the previous owner, he's found the missing bit. Happy days....

[The Gurnard]

That is good news Dydigital.

Although it would have been easy enough to cut a piece of ply to shape.. the aluminium joiner would have been difficult to make so it slotted into the floorboard behind it.

If you need any other ifo..or find you need the front template after all..just ask

[Dydigital]

After getting the missing bits was easy to see they could of been hard to make. Hopefully picking up a engine tonight.

[Dydigital]

Johnson 25hp short shaft.