Round the Tube Transducer holder

[smallribber]

With the older Honwave air floor inflatables they have the tabs sticking out the back which make them difficult to fit a transducer to.

I have done a search and it seems that there are some transducer holders that strap around the back of the tube. I can only seem to find these in the USA.

I was wondering if anyone has used these before and if they are available in the UK

Thanks

[Oldman2]

strap on.jpg


Make your own? Luggage strap and cut some rubber floor mat to size.

[smallribber]

Originally Posted by Oldman2

strap on.jpg


Make your own? Luggage strap and cut some rubber floor mat to size.

That looks a good solution. I would like one that is on the side of the tube so that it can be flipped up as you approach a beach or the ramp or in the real shallows. That is a good idea though. Might be a good project for the 3d Printer.

[Oldman2]

I did make a trial one with 2 joints out of 20mm round nylon rod that strapped on so it angled correctly while not fully below the tube. A quick slacken on the strap slides it up out of the waters reach on the tube.
I dont have trim tabs in the way so didnt go that rout in the end.

[jeffstevens763@g]

I'm sure you can get these with stick on tube mounts



https://www.force4.co.uk/item/Railbl...n=base&stock=2

[Tonus]

This looks perfect - I'd like one of these but the price would double with the postage from the US:


https://www.fishfindermounts.com/pro...ucer-mount-kit

https://www.youtube.com/watch?v=IwXHq6u6L9Y

[Tonus]

I guess I could make one with a strap and then loosen-rotate-tighten to put it down/up

[Tonus]

Here's a couple of options on Amazon UK


https://www.amazon.co.uk/Mount-Kit-f...=sports&sr=1-3


https://www.amazon.co.uk/Scotty-Floa.../dp/B004O0JBKC

[Oldman2]

That one in the video looks like a job for 3D Printer man

[bbuty]

not round the tube but:
https://f-ribsandsibs.com/forum/view...hp?f=20&t=4587