Hi all just got a yam300s inflatable with wood floor
It came with instruction book which say pressure
Of tubes but not the v keel or is it same psi.
Thanks darren
yes it should be. i wouldnt worry too much about the actual pressure as it changes constantly. it can be rock hard sat in the sun then go soft as soon as you put it in the water (due to cooling effect) just make sure it 'feels' about right once on the water, and let a bit of air out if you think its straining on the seams once back on land in the sun.
__________________
"Life may often suck, but the alternative is unacceptable" MMSI Sticker
You have the boat and engine, buy a pressure gauge. Check overall tube & air keel pressure to be 3.0 psi minimum once sib is floating after some minutes rest for pressure to stabilize. Running combo poorly inflated will stress & unglue transom side supports in the short run specially if using a heavier engine compared to much lighter less HP engines.
Thanks for the replies I have a tohatsu 9.8
4 stroke & a bravo auto pump plus all
The safety gear anchor rope flares vhf
Will be out first time on Sunday.
Thanks for the replies I have a tohatsu 9.8
4 stroke & a bravo auto pump plus all
The safety gear anchor rope flares vhf
Will be out first time on Sunday.
Northwind Challenger
