Hi Tpenewell.. welcome to the forum .. your question confused me until I realised motormouth probably translates to motor mount
I don’t know your boat..but in the UK that design was called nicknamed a donut transom. I have a small Avon with a similar design. They don’t use powerful outboards as the mount is not very substantial . On the Avon..its a curly metal frame which slots into rubber grips glued onto the tube. Max hp for mine was 2hp..any more power and the engine buckles up the tube.
A good boat to get afloat in..but an older design now.
My boat
A clearer photo of the motor mount ..from a photo off the net
Hope that helps some...your motor mount may be a bit different shape ? ..but Im sure its the same principle ?
If its completely different..then I guess .. Im the motormouth
Yes motor mount is correct, hate this auto correct. Your pictures are about what I expected and will make. Also see where oar locks would have been. Will probably use a little 4hp I have as I hadn't thought about the tubes collapsing. Thanks again.
