Ive made a single plug for a console extension. Its ready for painting, and my intention was to make a mould from the plug so I can get a good finish, being a one off im not sure if this is cost effective. However is there a paint solution, some sort of 2 pack maybe that is cheaper than 2 tins of durabuild?? I thought about skinning it with formica but the shapes a bit complicated.
Ive made a single plug for a console extension. Its ready for painting, and my intention was to make a mould from the plug so I can get a good finish, being a one off im not sure if this is cost effective. However is there a paint solution, some sort of 2 pack maybe that is cheaper than 2 tins of durabuild?? I thought about skinning it with formica but the shapes a bit complicated.
i would use the proper stuff, some 2 packs will pickle when you put gell near them, durabuild is easy to flat and polish so will save you time, just as information you can use button polish on small bare patch's and it will seal mdf
i would use the proper stuff, some 2 packs will pickle when you put gell near them, durabuild is easy to flat and polish so will save you time, just as information you can use button polish on small bare patch's and it will seal mdf
thanks biffer. Biggest issue is it only seems to be available in large quanities.. ANyone got small batches available??
should be able to find some local, take a container to a boat builder, it doesn't keep to well once open so someone will sell you a small amount, i haven't got any at the moment, try southampton yacht services at saxon wharf
